on 18 August 2014
Cheaper compared to many brands out there but be aware that there are dusts and specs of black debris inside that can clog up printer nozzle. Yes, I do have a sponge to clean the filament before it gets into extruder so I strongly believe the clog was inside the filament. Also, somehow at the beginning of the filament, I measured the diameter to be around 2.91 mm average but at the end it was more like 2.83 average which makes it almost unusable if you do not assist your print. The best use of this filament for me is a fast print for large nozzle (8mm E3D) ...Also, any small edges would warp but this is not as bad as the ABS in general.
on 6 May 2015
Very bright and vibrant which i like, but it doesn't flow as much as I'd like it to, you might want to raise the flow rate of the printer using this.
Brilliant price, arrived a day earlier than the 3 days estimated.
1 of 2 people found the following review helpful
on 2 September 2014
Printing on Prusa i3 @ 200C with room temp bed on blue tape.
Prints well, a bit stringy but not sure if that is my printing needing calibrating.
Colour is very much a 'bubblegum pink' on spool, although when printing for small objects its not as bright.
Gets 3/5 stars as the spool has some black bits of plastic specs in there(maybe 10 ish, but meant I had to setup a dust filter as it feeds in) and also when left over night tends to break if there is tension on the filament (I left it in the printer all setup 2 nights in a row and both times snapped by morning).