145 of 167 people found the following review helpful
3.0 out of 5 stars
It DOES Works, but hard to setup, manual shocking, support good, 14 Mar 2011
I fairly technically minded, so you'd think I would be able to setup this up relatively easily right? Wrong. After about 2 hours I gave up and rang the IT Support line from the website. I got through on the 3rd attempt (on a sunday afternoon --> so that is quite good service) and within 25 mins with the help of tech support had it fully working.
It works as a range extender.
Phone support is good and 24/7
Very cheap and cheerful
Small and lightweight
Manual is rubbish and does not reflect the actual setup options at times. It does not cover all points necessary to configure.
Setup is not obvious and if you are not willing to spend ages trying to get it to work, OR just contact the support line straight off this would be a nightmare to configure.
For the price, if you are fairly technical and willing to contact tech support (manufacturer website) it is worth the effort
If you have an unsecurred network, then setup is easy, but WHY DO YOU HAVE AN UNSECURRED NETWORK??!!
(Please don't use WEP for your network, too hackable!) USe WPA PSK
What I did to get it to as extender with tech support help: (if you are not technical this will not make sense)
Note: this is rough guide only.
0. If you use mac address filtering on router, add mac of tlink in before you start on router!
1. Connect tlink to pc with network cable.
2. Configure LAN TCP/IP connection with static ip of say 192.168.1.100 (or whatever, as long as is NOT .254 )
3. Open command prompt and ping tlink 192.168.254 (ip of tlink), subnet mask 255.255.255.0 (Eth address.)
4. If it responds to pings then happy days proceed to next step
5. Open tlink page by typing in internet explorer 192.168.1.254
6. enter password etc from manual
7. Flash firmware (optional) from manufacture website (I did)
7. Somewhere under LAN (or security) you can specify the LAN ip address.
if your router is (example 192.168.0.1) put in static ip of say 192.168.0.150 as the lan address of the tlink. Note this so called LAN address is ACTUALLY the wireless one as well! Default gateway should be ip of your router. Don't forget this! You may be prompted to reboot tlink at this stage.
8. Change your pc lan connection to be on 192.168.0 subnet. EG. 192.168.0.100 with static ip, Default gateway should be router ip and same for dns server. You should now be able to load the tlink page by entering 192.168.0.150 into internet explorer. Ie tlink should be on same subnet as router!
9. Once back in tlink admin page click Quick setup. Select various options including security type, network key, click SURVEY button to browse for your network, select by SSID and click connect.
It should auto fill most of the rest for you.
10. try using the diagnostic tab under tools to ping from tlink to the router. It should work, if not call tech support.
11. Change admin username and password!!
12. Backup configuration to bin file!
13. Disconnect cable.
14. Turn off/on tlink
15. Ping router from tlink, should work
16. Look at wireless network , strength should be better.
Don't forget to change chanel on router if connectivity ok, but strength of signal from router still no good (then reboot tlink)
ON my network it went from poor/fair to excellent.
I hope this shambolic review helps