Got this for a self build which is running brilliantly. Well made sturdy steel and hard wire mesh construction. Huge amount of internal mounting points for 5.25, 3.5 and floppy drive. Upto seven expansion slots on the rear. Fitted with a front 120mm fan. Provision for additional fans at rear and the side, the rear obviously being essential, and good for 120mm. A fairly hefty PSU can be fitted in this case to provide all the required power. Installation of drives is by means of screwless twistlocks, which are actually quite effective. I must, however, agree with the other reviewer about the rear expansion slots. Although these are also screwless, I personally didn't think that they were totally secure. So I used the grub screw supplied with the graphics and sound card and other expansion cards. Threaded holes are thankfully, pre-installed. Good through flow of cooling air, and the fans are quiet in operation. The front fan does gather dust on the wire mesh, but thankfully there is a dust filter behind the mesh and in front of the fan. Removing the dust from the mesh is simple, but getting to the dust filter involves removing the front mesh. Not difficult, but care needed when replacing the mesh. As for value, I've seen plastic cases for more money than this, and the quality of this case is outstanding. Put it on your shortlist. you won't be disappointed.