Power: Single Phase,50-60HZ,Double Insulated
RPM: Single Speed:13,000; Variable
Collet: Collets Type:2.4 or 3.2mm;
Spring Chuck type:0.3~3.2mm
This tools is design for carver, engrave, rout, grind, sharpen ,sand, polish, drill and more.
Unplug the tool form electrical outlet before loading a bit.
Press shaft lock button. Use the collet wrench to loosen the collet nut.
Inset the bit(not included),and tighten the collet securely. But avoid excess tightening of the collet nut and never use a damaged bit.
There is and ON/OFF switch. When the switch is on, the tool runs at 13,000 RPM. Slide the switch to find the speed needed from 3,000~13,000 RPM.
When finished, turn off the tool and unplug it.
Always unplug the tool when you change accessory or collet.
Do not engage the shaft lock button white the tool is running.
Do not use the machine near water or place it in water. If motor falls into water, unplug it immediately and do not touch the water.
Do not touch the bit or collet after using it because the bit and collet are too hot to be touched by bare hands.
Keep dust out of you eyes and lungs by using a protective eyewear or a dust mask.
Always "unplug it " after using the machine.
When not used, tool must be stored in a dry place and kept beyond the reach of children.
Clean the body with soft cloth.
Never use cleaning solvents or detergents .