The Solar Centre ECO Wedge Motion Welcome Light
The Eco Wedge is much brighter than you would expect from a solar light of this size.
The ECO Wedge Solar Motion Welcome Light is a highly compact unit that packs a powerful 80 lumens punch! Designed to guide you after dark using only the power of the sun, the Eco Wedge is wireless, reliable, weatherproof, fully automatic and easy to install. The ECO Wedge's elegant yet contemporary design makes it suitable for locations old and new and is designed to work reliably in UK winter.
The Eco Wedge is a highly compact unit that is just over 11cm high and 4cm deep.
How does it work?
During the day the sun charges the ECO Wedge's battery (supplied and installed) giving it the power it needs to work after dark. At night the Eco Wedge turns on automatically as soon as motion is detected and turns off automatically as soon as motion stops. In the morning the ECO Wedge stops detecting motion and begins charging ready for the night ahead. The ECO Wedge can be turned off completely at any time using the supplied activation pin. Please note that the Wedge will continue to charge up each day even if it is turned off.
How waterproof is the ECO Wedge Solar Motion Welcome Light?
The Solar Centre ECO Wedge Motion Welcome Light is IP65 rated making it among the most waterproof solar lighting units available.
How do I install it?
The ECO Wedge is one of the easiest solar lights to set-up because the unit is completely self-contained and there is no separate solar panel or wires to worry about. You can use a single nail to support the unit which is more than adequate, but we have included screws and rawl plugs in the box. Please note that the ECO Wedge must be installed outside in a location that gets some direct sunlight during the day to work to its full potential.
Installation using a single nail
The Eco Wedge is reliable, weatherproof, fully automatic and easy to install.
The ECO Wedge Motion Solar Welcome Light is an official Solar Centre branded product.
1. Position the Eco Wedge in your preferred location
2. Tap a nail into the hole just above the solar panel
3. Insert activation pin into the hole to the right of the sensor and gently press once until you hear a click
Installation using a rawlplug
Choosing your location
Position the Eco Wedge in your preferred location.
Mark the position of the hole just above the solar panel.
Put the Eco Wedge to one side and drill the mark.
Insert Rawl plug and screw the unit into place.
Insert activation pin into the hole to the right of the sensor and gently press once until you hear a click.
Height Width Depth
115mm 87mm 43mm