Have one to sell? Sell yours here
Surface Production Operations, Volume 1:: Design of Oil-Handling Systems and Facilities
 
 
Tell the Publisher!
I’d like to read this book on Kindle

Don't have a Kindle? Get your Kindle here, or download a FREE Kindle Reading App.

Surface Production Operations, Volume 1:: Design of Oil-Handling Systems and Facilities [Hardcover]

Ken Arnold , Maurice Stewart


Available from these sellers.


‹  Return to Product Overview

Inside This Book (Learn More)
First Sentence
The job of a production facility is to separate the well stream into three components, typically called "phases" (oil, gas, and water), and process these phases into some marketable product(s) or dispose of them in an environmentally acceptable manner. Read the first page
Browse Sample Pages
Front Cover | Copyright | Table of Contents | Excerpt | Index | Back Cover
Search inside this book:

Concordance (Learn More)
These are the most frequently used words in this book.
100  300  500  ansi  api  area  between  capacity  changes  chapter  class  compressor  conditions  control  cost  crude  data  design  diameter  drop  droplets  engineering  equation  equipment  example  facilities  factor  field  figure  flow  fluid  ft  gas  given  gravity  head  high  horizontal  inlet  interface  large  length  less  level  line  liquid  location  low  material  may  must  normally  number  oil  operating  phase  pipe  piping  plate  point  pressure  process  production  project  psi  psia  pump  rate  required  section  separation  separator  service  should  shown  shows  size  small  specific  standard  system  table  tank  temperature  thus  time  treater  treating  two  type  typical  unit  use  used  valve  velocity  vertical  vessel  viscosity  water 
‹  Return to Product Overview