This inexpensive bracket arrived in a padded envolope that contained the mount sealed in what appeared to be shrinkwrap. Be careful when unwrapping. The camera mounting bolts are translucent white. These bolts and their tiny nuts are easily overlooked when unwrapping the bracket and if you spray them onto the floor they are not the easiest things to find again. The bolts were a perfect fit through the mounting and the camera but I found it quite difficult, with my large fumbly fingers, to fit the tiny plastic nuts to the ends of the bolts without crossthreading. I note that an extra nut and bolt was supplied so perhaps others had this problem. The two pieces of the mount click together nicely but, for the configuration shown in the Amazon photograph, it is necessary to crop the end of the the bottom two bolts. I recommend this mounting because it adds weight and insulation to the camera PCB which otherwise is unprotected and tends to flail around on the end of its ribbon cable.