These LifeJacket floaty backdoor accessories are made for use with all GoPro cameras (including the new Hero 3) and fit perfectly on the existing backdoor housing to prevent your GoPro from sinking to the bottom of the ocean should you drop it or the mounting fail.
This version is the removable version. It uses 3M Dual Lock technology so you can use your existing backdoor, with or without a LifeJacket.
INSTRUCTIONS FOR USE:
Clean the surfaces of the GoPro backdoor and the LifeJacket. Ensure they are both completely dry before then peeling off the backing of the Dual Lock and sticking it to the GoPro backdoor. Apply firm pressure for 60 seconds. Full bond will not be reached for up to 24 hours so it's best to do this well in advance of wanting to use it.
Once the Dual Lock is fully bonded to the GoPro backdoor, push the LifeJacket against the Dual Lock on the backdoor and ensure it fully clicks in to place. The LifeJacket is now ready for use.
CAREFUL WHEN YOU REMOVE. Care should be taken when you remove the LifeJacket from the backdoor. You should try and separate the Dual Lock on the edge and then prise apart with fingers on the Dual Lock. Do not pull on the LifeJacket. The Dual Lock is extremely strong and you may pull the LifeJacket away from the Dual Lock!
It is not recommended to use the removable LifeJacket for motorised water sports or any situations where a strong impact could occur.
As with official GoPro floaty accessories, these will not float a GoPro attached to a suction cup mount.